#Tait t2020 software manual#
#Tait t2020 software software#

Set in the channel list a frequency for CTCSS on RX to 91.5 and 91.5 in the TX set. (eg Wires-X) on the 70cm repeater when its on if you have a 2020. Here are the program setting for CTCSS on RX so you dont hear the Digital noise Wires-X traffic can be very anoying on receivers that are not able to decode it. Programming the 70cm to mute digital traffic In the Tait Electronics (Aust) Pty Ltd, A2000-UIS Ver 1.0, T2000 Universal, The board fitting instruction are cover in the document:

#Tait t2020 software manual#

This manual is also available from the Repeater Builder Site: This details the 15 pin connector on the T2000-A80 line interface kit: Generic PTT circuit Version with isolation

#Tait t2020 software software#

The computer then outputs theДЄudio signal from the software into the mic input of the radio. Using RTS signal from the PC to trigger the PTT (Tx). Pinout to wire an RJ12 plug and replace the Mic for data communications: RJ12 Plug and Socket Viewed from the Front Straight through cable on many such devices without failures, however there are no guarantees. USB to serical devices tend to operate at the lower range of the RS232 voltage range.

To transistor level, to TTL components designed to operate a 5 volts. Note: There is some concern that this scheme connects RS232c voltage levels, that can be a high as 24 volts The schematic of the front control panel showing the microphone jack is here: Rear Power and Spearer Plug Power and Spearer Plug pinouts

This site gives a good explanation on the identification of Tait Radios: I haveДЄlso experimented with T2000 series radios for Allstar and APRS. T2000's on two meter and 70 cm to communicate on the local repeaters. With the T2000 series so I am no expert on Tait radios in general. Here is the collection of Tait T2000 radios I am using.

Programming the 70cm to mute digital traffic.